PCB and PCBA R&D Manufacturer. 
+86-755-81736919     sales@czypcb.com

Difficulties in PCB proofing of multi-layer circuit boards

Views: 502     Author: Site Editor     Publish Time: 2021-04-21      Origin: Site

Multi-layer circuit board PCB is more complicated than single-layer circuit board in terms of design and manufacturing, so problems may occur if you are not careful during the production process. So what difficulties should we avoid in multi-layer circuit board PCB proofing? The editor of Xianchengzhiyi will learn with you about the difficulties of multi-layer circuit board PCB proofing:


1. Difficulties in inter-layer alignment:


Due to the large number of layers in a multi-layer circuit board PCB, users have increasingly higher requirements for calibration of the PCB layer of the circuit board. Typically, alignment tolerances between layers are controlled at 75 microns. Considering the large unit size of multi-layer circuit boards, the high ambient temperature and humidity of the graphics conversion workshop, the dislocation overlap caused by the inconsistency of different core boards, the inter-layer positioning method, etc., the alignment control of multi-layer circuit boards is more difficult.


2. Difficulties in making internal circuit boards


Multilayer circuit boards use special materials such as high TG, high speed, high frequency, thick copper, and thin dielectric layers, which place high requirements on internal circuit board production and pattern size control. For example, the integrity of impedance signal transmission increases the difficulty of internal circuit board manufacturing. The width and line spacing are small, open circuits and short circuits are increased, short circuits are increased, and the pass rate is low; there are many thin line signal layers, and the probability of inner layer AOI leakage detection is increased; the inner core board is thin, easy to wrinkle, poorly exposed, and easy to curl when etching the machine; the high-level plates are mostly system boards, with larger unit sizes, and higher product scrap costs.


3. Difficulties in compression manufacturing


Many core boards and semi-cured boards are superimposed, and defects such as slippage, delamination, resin voids and bubble residue are prone to occur during stamping production. In the design of the laminated structure, the heat resistance, pressure resistance, glue content and dielectric thickness of the material should be fully considered, and a reasonable material pressing plan for the multi-layer circuit board should be formulated. Due to the large number of layers, expansion and contraction control and size coefficient compensation cannot maintain consistency, and thin interlayer insulation layers can easily lead to failure of interlayer reliability tests.


4. Difficulties in drilling holes


The use of special plates with high TG, high speed, high frequency and thick copper increases the difficulty of drilling roughness, drilling burrs and drilling dirt. There are many layers, the cumulative total copper thickness and plate thickness make it easy to break the cutting tool when drilling; there are many dense BGAs and narrow hole wall spacing, which causes CAF failure problems; the plate thickness can easily lead to angled drilling problems.

a920fc111f51865eab515ba1e6c3267

Shenzhen CZY Circuit Co., Ltd. is a high-tech enterprise specializing in the R & D, manufacturing and sales of PCB circuit boards and metal-based circuit boards.

QUICK LINK

CATEGORY

CONTACT US
Andy Chen: +86 - 17820397306
Mr. Lin: +86 - 13632666620
Email: sales@czypcb.com
Copyright Shenzhen CZY Circuit Co.,Ltd.  All rights reserved.