PCB and PCBA R&D Manufacturer. 
+86-755-81736919     sales@czypcb.com

Circuit board PCBA processing process

Views: 601     Author: Site Editor     Publish Time: 2021-03-05      Origin: Site

I always heard netizens say in the past two days: 'To see whether it is difficult to process a circuit PCBA board, first look at how a PCBA is processed.' Is this really the case? The editor of Chengzhiyi can learn the processing process of the circuit board PCB together:


  The first step is to get a circuit board PCBA, and first record the model, parameters, and location of all vitality components, especially the direction of the diode, triode, and IC gap. It is best to use a digital camera to take two photos of the component locations for later comparison.


  The second step is to remove all components and remove the tin from the PAD holes. Clean the PCBA with alcohol, then put it into the scanner, start POHTOSHOP, scan the screen printing surface in color, and print it out to prepare the PCBA for future copying.


  The third step is to lightly polish the TOP LAYER and BOTTOM LAYER layers with water gauze paper until the copper film shines. Place it in the scanner, start PHOTOSHOP, and scan the two layers in color. Note that the line PCBA must be placed at a certain distance in the scanner.


It should be horizontally and vertically, otherwise the scanned image will not be usable.


  The fourth step is to adjust the contrast and lightness of the canvas so that the part with copper film and the part without copper film are in strong contrast. Then convert the image to black and white and check whether the lines are clear. If not, repeat this step. If it is clear, save the image as black and white BMP format files TOP.BMP and BOT.BMP.


  The fifth step is to convert the two BMP format files into PROTEL format files respectively, and transfer the two layers in PROTEL. If the positions of PAD and VIA after the two layers are basically coincident, it indicates that the first few steps have been done well. If there is a deviation, repeat the third step.


The sixth step is to TOP. BMP is converted to TOP. For board-in-line PCBA, pay attention to convert it to the SILK layer, which is the yellow layer. Then you just trace the line on the TOP layer and place the device according to the drawing in the second step. After painting, delete the SILK layer.


  The seventh step is to BOT. BMP is converted into BOT. PCB, pay attention to convert it to the SILK layer, which is the yellow layer, and then just trace the line on the BOT layer. After drawing, delete the SILK layer and then copy the circuit board PCBA.


  Step 8: TOP in PROTEL. PCB and BOT. Bring in the circuit board PCBA and merge it into one picture and that’s it.

Step 9: Use a laser printer to print TOP, LAYER, BOTTOM, and LAYER on transparent film respectively (1:1 ratio), put the film on the circuit board PCBA, and compare whether there is an error. If it is correct, it means that the circuit board PCBA is copied this time.

That's OK.


Shenzhen CZY Circuit Co., Ltd. is a high-tech enterprise specializing in the R & D, manufacturing and sales of PCB circuit boards and metal-based circuit boards.

QUICK LINK

CATEGORY

CONTACT US
Andy Chen: +86 - 17820397306
Mr. Lin: +86 - 13632666620
Email: sales@czypcb.com
Copyright Shenzhen CZY Circuit Co.,Ltd.  All rights reserved.